Cowleys Pest Services Before & After Photos

We were sent out on a service call to a home in Rumson, NJ to treat for hornets. When we arrived, the homeowner mentioned that the nest was right above her backdoor. Sure enough, when we checked, we found an active bald-faced hornets! Bald-faced hornets are social stinging insects that are a close relative to yellow jackets. The surface of their upper midsection almost looks triangular from the side, and they have white markings on their face. One very important fact that you must know about bald-faced hornets is that they are EXTREMELY aggressive and will not hesitate to sting anything that invades their space. Their stings carry venom that makes the stings hurt, itch, and swell for about 24 hours!

First, we equipped our personal protective bee suit and treated the nest with a knockdown dusting application and then a knockdown liquid product. Both of these treatments will exterminate the bald-faced hornets almost immediately. Once a majority of the hornets were eliminated, we removed the nest, properly disposed of it, and then treated the area with a residual product to eliminate any returning bald-faced hornets & prevent them from building another nest. 

As we were servicing this customers property in Rumson, NJ we stumbled upon a few paper wasps beginning to build their nest up underneath the second story window. Paper wasps received their name from the paper-like material out of which they make their nests. They are semi-social stinging insects that usually have brown bodies with yellow or reddish markings. A sting from a paper wasp can be extremely painful and can cause allergic reactions in some people.

We grabbed our extendable pole, attached a knockdown dusting application to it, and liberally treated the nest. This product rapidly neutralizes the paper wasps. A short while later we removed the nest, disposed of it, and applied a residual application to the area to prevent the paper wasps from returning and building a new nest.

Here is a great “before and after” photo comparison where I installed a vent block to replace, what frankly, was a big mess. This project was completed for a home in Avon by the Sea, NJ. Whenever we install a dehumidifier in a crawl space, we strongly recommend to homeowners to block the crawl space vents, which helps keep outside humid air from entering the basement (not to mention insects!). Installation of a commercial-grade dehumidifier is the single most important way for homeowners to prevent mold growth and other problems resulting from sustained high humidity in crawl spaces and basements. ideally, these subterranean areas should be encapsulated to keep humid air from entering the crawl space. Building scientists that study indoor airflow have found that vented crawl spaces do exactly what homeowners want to prevent —  allowing hot humid outdoor air enter the crawl space. There is a popular misconception that vented crawl spaces expel hot humid air, when in fact, the opposite is true. However, even if a homeowner decides to not fully encapsulate their crawl space, at a minimum, we strongly recommend that homeowners at least block the crawl space vents since these are, by far, the largest entry points for outside air.

To block the vents, we cut Silverglo insulation to size. SliverGlo insulation is an Expanded Polystyrene Foam (EPS) insulation that contains graphite. This lightweight, rigid, closed-cell insulation is 24% more efficient than over-the-counter batt and foam insulations. Its closed-cell structure provides minimal water absorption and low vapor permanence. As an added benefit, SilverGlo is coated with a mold-resistant aluminum that naturally enhancing primary sources of light, dramatically increasing the luminosity of even a single bulb. After setting in the insulation in the vent space, we then spray a hardening foam around the outside edges to completely block off any airflow. 

Homes that were built with dirt floor crawl space foundations became very popular after World War II when there was a huge demand for new and more affordable homes. Crawl spaces could be built faster and much cheaper than basements. However, no one could foresee the major issues that dirt floor crawl spaces can have on a home. For instance, this homeowner in Avon-by-the-Sea, NJ was experiencing incredibly high humidity levels and abundant moisture buildup in his crawl space. If left untreated any longer, this could lead to mold and mildew growth and structural damage. Fortunately, the homeowner decided to have Cowleys encapsulate his crawl space.

The benefits of crawl space encapsulation are dramatic. Relative humidity will stay below 70% even if the outdoor humidity is higher. You’ll save on your utility bills, have better air quality in the crawl space, and not only keep out moisture, but also keep out unwanted pests!

First, we cleared out all the debris and installed a drainage matting. A drainage matting is a dimpled plastic mat that allows water to work its way over to the sump pump. Next, we replaced the old, broken sump pump with a smart drain sump pump to allow any water that gets on top of the liner to flow down underneath the ground. 

Then, we installed a clean space liner covering the ground of the entire crawl space. A clean space liner is a super-durable, 20mil plastic sheet material designed to permanently prevent moisture, outside air, and pests from getting into your crawl space. The vapor barrier is installed over the foundation walls and floor to create a continuous air and moisture barrier. Finally, to control the humidity levels we installed a Sani-Dry dehumidifier. These machines are a powerful energy-efficient dehumidifier that outperforms standard household dehumidifiers by as much as 10 times while using the same amount of energy to run. The SaniDry XP directs the extracted water pulled out of the air directly into the sump pump. 

Now the humidity levels will be at a comfortable level, the value of the home has increased, and there will be no more moisture buildup in the crawl space.

This new homeowner recently purchased a property in Avon by the Sea, NJ and wanted her crawl space encapsulated. So she contacted Crawl Space Solutions and we were sent out to do just that.

First, we sanitized the crawl space and removed all of the debris that was inside. After that, we installed a dimpled plastic drainage matting and a vapor barrier. The vapor barrier is a heavy-duty, 20-mil 7-ply sandwich of high and low-density polyethylene with a polyester-cord reinforcement. It's also extremely durable and treated with an antimicrobial to prevent mold. By installing the vapor barrier over the foundation walls and floor will create a continuous air and moisture barrier.

Lastly, we installed a Sani-Dry Sedona commercial-grade dehumidifier. The Sedona directs the extracted water pulled out of the air directly into the sump pump and will control the humidity levels in the crawl space. The end result is a healthy, moisture controlled, crawl space that the homeowner can also use for extra storage.